EZTrim EZProcess Rosin Press

SKU
EZPROROSP
$4,000.00
In stock
Killer Price

This item is heavily discounted and does not qualify for other sales or discounts.

EZTrim EZProcess Rosin Press is available to buy in increments of 1
Rosin press with 2 heat plates, individually controlled with a thermocouple and controller. This manual press allows you to control the amount of pressure (up to 12 tons) over time, allowing you to get the rosin off the heat as quickly as possible to avoid burning the product, enabling up to 60% yields. It can press your flowers, keif, leaf, and bubble hash, over 1 oz of product at a time.
Description
EZTrim EZProcess Rosin Press

EZTRIM’s EZProcess Rosin Press uses heat and pressure for extraction that enables up to 60% yields. You can press your flowers, keif, leaf, and bubble hash. No need for butane, co2, purging or heavy equipment that is dangerous to use. The EZProcess Rosin Press is the world’s best rosin press. The EZProcess Rosin Press has 2 heat plates that are individually controlled with a thermocouple and controller. The EZProcess Rosin Press is a manual press. The benefit of pressing manually is that it allows you to control the amount of pressure over time. We have found that pneumatic pressing tends to press to quickly, causing blown out tubes and lower yields. TheEZProcess Rosin Press was also designed to get the rosin off the heat as quickly as possible to avoid burning the product. The micron tubes are exactly the same width and length of the heat plates. This forces the product off of the heat as soon as you squish. The EZProcess Rosin Press can press over 1 oz of product at a time and can create up to 60% yields. The EZProcess Rosin Press also has the most pressure on the market at a true 12 tons.

The EZProcess Rosin Press comes with everything needed to start pressing rosin today. This includes: stand, press, micron tubes, heat plates and 2x digital thermostat controllers.




Instructions for use:
  1. Power on the unit
  2. Set the temperature to 150°-200° F for both plates (temp is preset at factory to 170° F)
  3. Fill the micron tubes with 1 oz. of product
  4. Distribute the product evenly through the tube
  5. Fold over 2” of the tube at the open end
  6. Place the tube between 2 sheets of parchment paper
  7. Place the tube and parchment paper centered over the heat plate
  8. Release piston until raised to its highest point and tighten release screw
  9. With full top/bottom strokes pump the jack 21 – 23 times. Do not exceed 23 full pumps on the jack as it can damage the frame
  10. Hold in the pressed position for 30sec. to 1 minute
  11. Release the heat plates until the piston rises to its highest point and remove the parchment paper and tubes
  12. Empty the micron tubes and repeat steps 3 – 11
More Information
Name EZTrim EZProcess Rosin Press
Brand EZ Trim
SKU EZPROROSP
MSRP $4,000.00
Weight (lbs) 100
Dimensions Assembled Dimensions – L 26" W 19.5" H 48.5"
Voltage 120v
Watts 800w
Amps 6 amps