Titan Controls Atlas 1 CO2 Monitor / Controller w/ Remote Sensor

Atlas® 1 CO2 Monitor/Controller comes with a 25 foot remote sensor. It features adjustable set point and elevation levels, a built in 'self calibration' function and an integrated photocell that enables operation in daytime hours only, when the plants need CO2. Simple to use and easy to operate. 15 Amps/120 Volt/60 Hz. Replacement sensor can be purchased separately. The sensor comes factory calibrated for precise CO2 readings and utilizes low voltage technology to avoid Radio Frequency Interference (RFI) from electronic ballasts.

• Digital control board delivers precision CO2 control
• Maximize your garden's CO2 level while minimizing CO2 tank or LP consumption
• Adjust CO2 set point, modify elevation or calibrate with just two buttons
• Can control both bottled CO2 tanks or CO2 generators!
• Controls any CO2 equipment that is operated by 120 volt power
• Durable powder coated, steel enclosure will stand up to the toughest conditions
• Adds CO2 only during daylight period by using the controllers integrated photocell
• 50 parts per million (ppm) deadband/hysteresis built into set point
• Memory retains controllers settings even when the power is off
• ETL listed for use in commercial applications
• 15 amps/120 Volt/60 Hz
• 3 year warranty

If you're confused or have questions about CO2, check out our CO2 buyers guide.

Want to know know long your tank will last in your growing space? Using a co2 calculator will help you use your CO2 efficiently.

Easy Guide
Instructions

Controller Specifications:

Sampling Method = Infrared Diffusion

Measurement Range = 300 PPM to 5100 PPM

Control Range = 0 PPM to 2050 PPM

Accuracy: +/- 5% (total reading)

Response Time: Approximately 45 seconds

Fixed Hysteresis/Deadband = 50 PPM (centered)

Signal Update: Displayed CO2 PPM reading updates once every 3 seconds

Warm-up Time: Approximately 30 minutes

Recommended Calibration Interval = Every 3 years

Stability: Typical Deviation ±75 PPM a year

Operating Temperature = 32° F (0°C) to 120° F (50°C)

Input Voltage = 120VAC, 60 Hz.

Output Voltage = 120VAC, 60 Hz.

Maximum Operating Amperage: 15 Amps

RoHS Compliant = Yes

Warranty is void if non-copper wiring is used. It is recommended that you re-tighten all connections every 60 to 90 days to avoid possible arcing and potential input terminal meltdown. Arcing power due to loose connections is not covered under warranty.