TrolMaster QCD-CL1 CO2 Sensor Climate & Lighting Master Controller

The TrolMaster QCD-CL1 CO2 Sensor Climate & Lighting Master Controller is a 32-BIT ARM microprocessor based climate and lighting timing controller. It can control the CO2 PPM, humidity, and temperature of your grow room accurately. It features a remote sensor with a photocell for night function and proper usage of CO2.

The TrolMaster QCD-CL1 CO2 Sensor Climate & Lighting Master Controller can control the recycling time of fans, light, light mover for your grow room accurately. It features a remote temperature sensor; it will detect unsafe (high) temperatures and turn off the HID lights in the event of a ventilation failure. The remote NTC temperature sensor can be placed up to 15 feet from the controller to monitor over temperature and shut down HID light.

The controller has 4 AC receptacle outlets and one DC24V outlet:

• Temperature device output:
  • In decrease mode, plugged into a fan to exhaust air if the temperature is above the set point. Or the output can be used to activate an A/C unit.
  • In increase mode, the output is intended to be hooked up to a heat source.
• Humidity device output: it can be used to dehumidify or humidify the grow room. You can have a dehumidifier or fan plugged in to dehumidify your room. When in humidification mode, a humidifier may be used.
• Light device output: The outlet is intended to operate HID lights. You may use up to 600 Watts HID light. The QCD-CL1 may also be used to operate larger lighting banks by plugging the relay trigger cord set into this output and setting the timer to run your lights. Do not exceed 600 Watts per outlet when using these outputs.
• Recycling Timer Output: This output can be used with a pump, fan, etc.
• CO2 generator DC24V output: connect CO2 generator to enrich your CO2 PPM in your grow room depending on the CO2 PPM level sensed. The output also can be connected to 24VDC solenoid valve for a CO2 tank. For 50/60Hz 24VAC solenoid or 120/240VAC solenoid needed to use compatible DC to AC inverter. Note: the outlet could output 24VDC/0.4A max.

The digital nature of the TrolMaster QCD-CL1 Master Controller allows you to control your grow room to whatever specifications you desire. QCD-CL1 is built with the highest quality components to assure years of trouble-free climate control.

• Input Voltage: 120 Volts AC
• Maximum Amperage: 14.5 amps @ 120 VAC
• Backup Battery: CR1220
• Remote COMBO Probe Cable Length: 15 ft
• Temperature Control Range: 41o to 113o F
• Temperature Accuracy: +/- 2o F
• Temperature Dead-band (hysteresis): Adjustable
• Humidity Control Range: 5% to 95% rH
• Humidity Accuracy: +/- 3% rH
• Humidity Dead-band (hysteresis): Adjustable
• CO2 Control Range: 380-2500 PPM
• CO2 Accuracy: +/- 50 PPM
• Remote NTC Temperature Probe Cable Length: 15 ft
• High Temperature Shutdown: Adjustable
• Maximum Lighting Watts: *1200 watts
• Recycling ON Timer Range: 1 second to 96 hours
• Recycling OFF Timer Range: 1 second to 96 hours
• Dimensions: 180x175x75mm