Anden A95 Filter Size: 10 x 12 x 1, and Not the A95F
The A95 and the A95F are a letter apart on the data plate and a panel apart in the filter frame. Anden lists part 5771 at 10 x 12 x 1 for the A95. The A95F takes part 5770 at 12 x 12 x 1 instead. Two inches on a single edge is enough that the wrong one will not seat properly. A filter that does not seal is a filter the air goes around instead of through. So the first job is the letter on the plate, not the number. Get that right and the rest is straightforward: one machine, one panel, part 5771.
What a MERV 11 Panel Does for an Anden A95
Only one panel in Anden's dehumidifier range is smaller than this one, the A70's. A small face has the least media to work with, which makes staying on top of it worthwhile. The EPA holds MERV 11 to 65 percent or better capture from 1 to 3 microns, and 85 percent from 3 to 10. That is the fraction a grow room throws about: leaf dust, trimmed material, grit off the media. Anden builds it as a multi-pleat, folding the media to get more surface into a small frame. What sits behind it is the evaporator coil. Keeping that face clean is the difference between a machine holding its rated pints and one working harder for fewer. Anden's timing advice runs across their whole line, and it suits a grower better than most. Change the filter every 12 weeks, or at the end of a harvest.
Key Features
- Anden part 5771: The number to match for a single panel, which is how these are stocked
- 10 x 12 x 1 as Anden publishes it: Confirmed in Anden's own accessory listing, so the catalogue and a tape measure agree
- Not the A95F panel: The A95F takes part 5770 at 12 x 12 x 1; check the letter on the data plate before matching a size
- MERV 11 multi-pleat media: EPA holds the grade to 65 percent or better from 1 to 3 microns and 85 percent from 3 to 10
- Folded media in a small frame: The multi-pleat build puts more surface into one of the smallest frames Anden lists, which is where it counts most
- Keeps the coil clean: A loaded face makes the unit draw full power for fewer pints, so fresh media is the simplest way to hold output
- Every 12 weeks or every harvest: Anden's published interval, tied to the grow cycle rather than to a calendar quarter
Technical Specifications
| Specification | Value |
|---|---|
| Anden part number | 5771 |
| Filtration grade | MERV 11 |
| Media type | Multi-pleat |
| Size | 10 x 12 x 1 in |
| Filters per unit | 1 |
| Compatible models | Anden A95 |
| Often confused with | Anden 5770, 12 x 12 x 1, for the A95F |
| Replacement interval | Every 12 weeks or at the end of a harvest (Anden) |
More on how Quest and Anden size their filters, what the MERV numbers mean and when each brand says to change them: Quest and Anden Filters: Sizes, Ratings and Replacement Timing.