Anden A100 Dehumidifier, 100 Pints/Day | 120V, 280 CFM

Anden A100 Dehumidifier Specs for Tents and Small Grow Rooms

The Anden A100 is a commercial-grade refrigerant dehumidifier sized for tents, small flower rooms and drying spaces that need steady moisture removal. It pulls 100 pints per day at 80°F and 60% RH while drawing 6.9 amps and 750 watts from a standard 120V circuit. That works out to 2.6 L/kWh, so the power going through the coil turns into water in the drain line rather than wasted heat. The blower moves 280 CFM through 10-inch duct collars at 55 dBA, quiet enough to hang inside the room you work in. The cabinet measures 14 x 15 x 26 inches and weighs 64 lb, so two people can lift it onto the Model 5660 hanging kit. A built-in digital control sets humidity right on the unit, and the control head swaps from top to front in the field. Incoming air passes a MERV 11 filter before it reaches the coil, which keeps dust and leaf debris off the fins. Dehumidification runs on inlet air from 50°F to 104°F, covering hot lights-on hours and cooler nights. It is a compact, quiet unit. Condensate leaves through a 3/4-inch MNPT connection to a floor or waste drain, and the fitting and tubing come in the box.

A 100 Pint Dehumidifier That Hangs, Ducts or Stands on the Floor

Most growers set it up one of three ways. Suspended from the ceiling, it keeps the floor clear for benches and pulls the humid air that collects above the canopy. Ducted, it draws from one side of the room and returns dry air to the other, which also stirs CO2 and evens out temperature. Freestanding, it sits beside the drain and runs straight from the included tubing. The real moisture load arrives at lights-off, when plants keep transpiring while the room cools and RH climbs fast. Set the target a few points under your VPD goal and let it cycle. It shuts off at set point, then samples the air before restarting. For control at canopy height, the optional A77 remote mounts where the plants are instead of where the unit hangs. Any room controller with a dry contact closure can run it too, which suits growers already automating lights and fans. This capacity fits a single tent or small room, so a large flower room usually runs two or more units spaced across the space. Rinse or swap the filter on a schedule, because a loaded filter cuts airflow and water removal together. The five-year warranty covers the refrigeration system along with every other part.

Key Features

• Ducted or Suspended Install: Inlet and outlet collars take flex duct or hard pipe. An outlet backdraft damper stops air running backward when the unit cycles off.
• Digital Control With Remote Option: The onboard display sets RH directly, while the optional A77 or any dry-contact controller moves control to canopy height.
• MERV 11 Coil Protection: The 5895 filter catches dust and plant debris before it coats the coil, protecting both capacity and efficiency over a long run.
• Corrosion-Resistant Aluminum Coil: The coil is built for the wet, nutrient-laden air of a grow room, where bare copper and steel corrode early.
• Drain Kit Included: The barbed drain fitting and 10 ft of tubing ship with the unit, so a gravity drain is ready on day one.
• ETL Listed, Five-Year Warranty: The cabinet carries the Intertek ETL mark, and the warranty covers every part including the refrigeration system.

Technical Specifications