B.LITE 1000W Premium DE HPS Fixture w/ Bulb (240V)

A DE HPS Grow Light That Arrives With Its Lamp

Everything needed to light a flowering room comes in one box with this B.Lite Premium kit. It pairs a 1000W digital ballast and an open double ended reflector with a matching DE lamp. The ballast runs on 240VAC, the standard circuit for most dedicated grow rooms. Power factor reaches 0.98 at full load, and harmonic distortion stays under 10%. The lay-flat housing keeps the whole fixture low, so short rooms keep more height for the plants. ALMECO Vega and Alanod MIRO aluminum line the enlarged reflector and push light wide and even. The ballast dial steps through 600W, 750W, 1000W and a Super Lumen boost. Smart Start ignition and soft start ease the lamp to full output each time it strikes. Hot lamp re-strike brings it back safely after a brief outage. The fixture also accepts a 1000W DE MH lamp for the vegetative stage.

Setting Up a 1000 Watt Double Ended HPS in the Room

Mount the fixture level and confirm the circuit is rated for the full load before plugging in. Handle the lamp with clean gloves and seat both ends squarely in the sockets. Connect the RJ14 kit to link this light with the next one in the row. The B.Lite Master Zone Controller can then dim the whole zone together from zero to full power. Without it, the dial on each ballast sets its own output. Start new plants at a lower setting and raise it as the canopy fills out. Automatic frequency adjustment keeps the lamp steady through small voltage swings. Full circuit protection and RF shielding look after the ballast and nearby electronics. Keep room temperature between freezing and 35 degrees C, with humidity from 25 to 70 percent. Dust the reflector between crops to hold light output where you set it.

Key Features

• Lamp Included: Ships with a 1000W DE lamp, ready to run.
• 240V Input: Built for dedicated 240V grow room circuits.
• Four Power Settings: 600W, 750W, 1000W and Super Lumen.
• Zone Control Ready: 0-1000W dimming with the B.Lite Master Zone Controller via RJ14.
• Vega and MIRO Reflector: High-reflectance aluminum with an enlarged spread.
• Lay-Flat Design: Low profile for rooms with limited height.

Technical Specifications