Skip to product information
1 of 2
Brand: GROW1

GROW1 Neoprene Inserts Black 2in (132pcs/Pack)

GROW1 Neoprene Inserts Black 2in (132pcs/Pack)

SKU: SKU:171002

Ordering a large quantity of this item?
As long as the order total is more than $2K you can:

Regular price $30.53 USD
Regular price $30.53 USD Sale price $30.53 USD
Sale Sold out
Shipping calculated at checkout.

GROW1 black neoprene inserts, 2 in across and 0.75 in thick, in a pack of 132. Each soft disc has a slit to the center that holds a cutting upright in a net pot or cloner without media.

View full details

Black Neoprene Inserts for Cuttings Without Media

Aeroponic cloners and net-pot systems need something soft to hold a cutting at the right height. These GROW1 discs do that job, at 2 in across and 0.75 in thick. A slit runs from the edge to the center, so a stem slides in sideways and the foam closes around it. The soft neoprene grips without crushing, which protects the tender tissue at the base of a fresh cut. The disc also keeps the cutting from rocking or slipping, which a hard plastic lid cannot do. With the stem held still, the cut end stays in the mist or water zone where new roots form. Black reads as neutral in any tray, so the inserts blend into the lid of most cloners. Every pack holds 132 separate inserts. That fills a large cloner several times over, or stocks a whole season of net-pot starts. The pack weighs about 0.7 lb.

Using Clone Collars in Cloners and Net Pots

Take a cutting, trim the lower leaves and make a clean angled cut at the base. Open the slit with two fingers, slide the stem in and let the foam close. Set the depth so an inch or two of stem hangs below the disc. Press the insert into the cloner lid or a 2 inch net pot until it sits snug. In an aeroponic cloner, the hanging stem should sit in the spray, not above it. In a DWC or net-cup system, the base of the stem should reach the moisture zone. Once roots show, lift the whole insert out and move the plant on with its collar. The disc slips off the stem at transplant without tearing the new roots. Between runs, clean the inserts and soak them in a diluted sanitizer before reuse. Rinse well and let them dry fully, then store them out of the sun.

Key Features

  • 2 in Diameter: Sized to sit inside 2 inch net pots.
  • 0.75 in Thick: Enough depth to hold a stem upright without media.
  • Center Slit: Stems slide in from the side and the foam closes around them.
  • Soft Neoprene: Grips without crushing tender tissue.
  • Black Color: Neutral in any tray or cloner lid.
  • 132-Piece Pack: Enough to fill a large cloner several times over.

Technical Specifications

Specification Value
Brand GROW1
Product Neoprene insert, cloning collar
Color Black
Diameter 2 in
Thickness 0.75 in
Material Neoprene
Design Slit from edge to center
Pieces per Pack 132
Pack Weight 0.7 lb
Package Dimensions 17 x 12 x 2 in
Uses Cloning machines, aeroponics, net pots, hydroponic systems
SKU 171002
UPC 816731011167