Skip to product information
1 of 1
Brand: GROW1

GROW1 Neoprene Inserts Yellow 2in (100pcs/Pack)

GROW1 Neoprene Inserts Yellow 2in (100pcs/Pack)

SKU: SKU:171204

Ordering a large quantity of this item?
As long as the order total is more than $2K you can:

Regular price $23.13 USD
Regular price $23.13 USD Sale price $23.13 USD
Sale Sold out
Shipping calculated at checkout.

GROW1 yellow cloning collars, 2 in across and 0.5 in thick, 100 per pack. Made from soft neoprene with a slit to the center, they hold cuttings steady over the mist in commercial or homemade cloners.

View full details

Yellow Cloning Collars That Hold Cuttings in the Mist

Every aeroponic cloner depends on the collar that keeps a cutting hanging at the right depth. These GROW1 discs measure 2 in across and 0.5 in thick, made from soft neoprene. A slit runs from the rim to the center, so the stem goes in from the side instead of being pushed through. The foam closes around the stem with a gentle grip that does not bruise the tissue. Because the cutting cannot rock or slide, its base stays inside the spray where roots form fastest. Yellow is easy to see under dim light, so it is quick to check which sites are filled. The color also gives a clear marker when one batch or variety needs to stand apart from the rest. Every pack holds 100 collars in the same bright shade. That fills a large commercial cloner or several homemade bucket units. The pack weighs about 0.5 lb and stores flat on a shelf.

Fitting Collars to a Bucket Cloner

A homemade bucket unit is usually a lid drilled for 2 inch net pots over a pump and sprayers. Drill the holes so each net pot sits flush, then test the spray with the lid off. Prepare each cutting with a clean angled cut and remove the lower leaves. Open the slit, slide the stem in and leave an inch or two hanging below the disc. Press the collar into its net pot and set the pot back in the lid. Look underneath once more to make sure every stem tip sits in the mist. Commercial cloners with 2 inch sites take the collars directly, without a net pot. Once the roots are an inch long, lift each plant out with its collar still attached. Slide the collar off at transplant, then wash all inserts in warm water. A soak in diluted sanitizer and a full dry prepares them for the next run.

Key Features

  • 2 in Diameter: Fits 2 inch net pots and 2 inch cloner sites.
  • 0.5 in Thick: Holds a cutting at a steady depth over the spray.
  • Center Slit: Stems go in from the side, not pushed through.
  • Soft Neoprene: A gentle grip that does not bruise the stem.
  • Yellow Color: Easy to see under dim light and useful for marking batches.
  • 100-Piece Pack: Fills a large cloner or several bucket units.

Technical Specifications

Specification Value
Brand GROW1
Product Neoprene insert, cloning collar
Color Yellow
Diameter 2 in
Thickness 0.5 in
Material Neoprene
Design Slit from edge to center
Pieces per Pack 100
Pack Weight 0.5 lb
Package Dimensions 12 x 8 x 2 in
Uses Aeroponic cloners, bucket cloners, net pots, hydroponic systems
SKU 171204
UPC 816731013550