Growonix Ballast for 12 GPM UV systems

GrowoniX 12 GPM UV Ballast for Reliable Reservoir Sterilization

This driver is the electronic ballast that fires the UV-C lamp inside the 55W stainless steel sterilizer. It holds a steady arc so the lamp hits full germicidal output. The ballast runs on standard 120 VAC and drives the 55W UV-C lamp treating water at up to 12 gallons per minute. When a ballast fails, the lamp goes dark and pathogens pass straight through. Swapping in the matched driver restores the system's 99.9% microorganism kill.

Matched 55W UV Sterilizer Replacement Ballast

Ballasts usually quit before the stainless chamber does. A lamp-life countdown that has hit zero means the driver has logged its rated hours. This unit mounts to the wall beside the reactor, wiring back to the lamp connector and ground stud like the original. Growers running recirculating reservoirs or larger RO systems lean on this sterilizer to keep root-zone pathogens in check. Cut power and let the system cool about ten minutes before you service it. Pair the ballast with a matching GrowoniX UV-C lamp, and plan on a fresh lamp roughly every 12 months for consistent output.

Key Features

• 55W UV-C Drive: Powers the 55-watt germicidal lamp used in the 12 GPM GrowoniX sterilizer for full-strength UV-C output.
• 120 VAC Input: Runs off a standard wall outlet, so no special wiring is needed at the reservoir.
• Direct-Fit Replacement: Wires to the same lamp connector and ground stud as the factory ballast for a straight swap.
• Wall-Mount Design: Mounts beside the reactor chamber to keep the driver dry and off the floor.
• Restores 12 GPM Sterilization: Brings the system back to 99.9% microorganism destruction after a ballast or lamp-timer failure.

Technical Specifications