Hydro Halo Water Ring 6 inch w/ 3 leg support

Hydro Halo Water Ring 6 inch for Even Top-Feed Irrigation

This 6-inch water ring circles the plant with 54 evenly spaced pores. Water and nutrient solution reach the whole root zone instead of one drip point. A 1-inch gap lets you set the ring around an established stalk without snapping it. The ring runs off standard ½" I.D. tubing. Most growers lay it flat on the medium and tuck the feed line to the back. In soil, coco, or soilless mixes, the pot's outer edge stays as wet as the center.

Match the Container Drip Irrigation Ring to Your Pot Size

The 6-inch ring fits smaller containers best, where the pore circle sits right over the root mass. For larger pots, the 9-inch and 12-inch Hydro Halo rings run the same pattern across a wider footprint. Three removable stakes hold the ring flat so it keeps its feed position once the pump starts. Because it ties into common ½" fittings, one ring or fifty drop into the same manifold. Adding ½" ball valves per line evens out pressure on long runs. It rinses clean between cycles. One caveat: at low line pressure the pores nearest the inlet flow a little heavier, so a valve per ring matters more on long rows.

Key Features

• 54 Evenly Spaced Pores: Full-circle output covers the entire root zone and removes the dry pockets a single emitter leaves at the pot's edge.
• 1-Inch Placement Gap: Sets around an established stalk mid-grow without stressing or damaging the main stem.
• Three Removable Stakes: Hold the ring flat and in position during irrigation, and pull out when you want to run it stake-free.
• ½" Tubing and Fitting Compatible: Connects to standard ½" I.D. tubing and fittings, so it drops into existing drip manifolds with no proprietary adapters.
• Indoor or Outdoor Use: Runs in hydroponic or soil gardens and rinses clean for reuse across multiple cycles.

Technical Specifications