Iluminar IL LED IP67 Power Cord Set 277V | iLW, iL23, iL47, iL63 | 1.53m

Iluminar IP67 Power Cord for 277V iLW and iLBar Fixtures

The Iluminar IP67 cord delivers 277V input to iLW, iL23, iL47, and iL63 fixtures through a sealed quick-affix mate. Cord length runs 1.53 m / 9.8 ft, enough to reach an overhead 277V conduit drop without splices. Each piece uses an IP67 connector, so the install pulls a single sealed mate at the fixture end. All four iLBar models share the same iLW power cord 277V input port, so one SKU covers your bench. Installation takes seconds. The seal holds in vapor-saturated rooms across normal service intervals between fixture cleans.

Iluminar 277V Power Cord Set Across the iL23 iL47 iL63 Lineup

Growers typically place the cord run along a clean overhead path, away from sprayer heads and irrigation supply lines. 277V is a commercial-circuit voltage and does not substitute for 120V or 240V drops. Confirm voltage at the panel before pulling fixtures into a new room. The IP67 rating matters once recirculating fans push humidity above 70% in late flower. Plan one cord per fixture for input, then bridge fixture-to-fixture with the iluminar daisy chain power cord. The 9.8 ft length suits standard rolling bench heights without coiling slack near the canopy. The quick-affix connector mates without tools, which speeds install for techs swapping a fixture mid-run.

Key Features

• IP67 Quick-Affix Connector: Sealed mating connector resists humidity for late-flower runs above 70% RH
• 1.53 m / 9.8 ft Length: Reaches overhead 277V conduit drops without extra junction boxes
• iLW iL23 iL47 iL63 Compatibility: One cord SKU covers the iLBar series across small to commercial benches
• Tool-Free Install: Quick-affix mate completes in seconds during fixture swaps
• Commercial 277V Build: Designed for 277V circuits common in commercial cultivation rooms

Technical Specifications