iLuminar Under Canopy 6 ft Power Cord Extension 0-10V | 120V/240V/277V Daisy Chain

iLuminar Under Canopy Power Cord Extension with 0-10V Daisy Chain Port

The Under Canopy cord runs 6 ft between iLuminar Under Canopy 160W fixtures. It adds a built-in 0-10V dimming port for daisy-chained control across the chain. Voltage support spans 120V, 240V, and 277V, with daisy-chain capacity of 12 fixtures on 120V, 24 on 240V, and 28 on 277V. The 0-10V control line travels alongside the AC power on a single cord. That keeps under-canopy wiring tight against rack uprights and out of plant contact. Primary compatibility is the 160W Under Canopy fixtures in R-Spectrum and Full Spectrum versions. Cross-brand pairings work where the connector and pinout match.

iLuminar Under Canopy Cord with Voltage Scaling for 120V, 240V, and 277V

Growers typically place under-canopy bars about 6 to 12 inches above the rack tier they light. The 6 ft cord gives enough slack to reach across a 4-foot bench without coiling on the canopy. Daisy-chain capacity scales with circuit voltage. A 277V commercial circuit drives 28 fixtures off a single feed. That is why most multi-tier vertical builds run on 277V where the panel allows it. The 0-10V port supports compatible drivers without an adapter. Cross-brand pairings work where the connector matches. Pair it with proper 277V whips at the panel side of the chain.

Key Features

• 0-10V Daisy Chain Port: Sends a single dim signal across the entire chain on compatible drivers
• Voltage Scaling: Same cord supports 120V (12 fixtures), 240V (24 fixtures), 277V (28 fixtures)
• 6 ft Length: Reaches across 4-foot benches without slack coiling on top of the canopy
• Under Canopy 160W Compatibility: Direct-fit for iLuminar Under Canopy R-Spectrum and Full Spectrum fixtures
• Commercial 277V Friendly: Drives 28 fixtures off a single 277V feed for multi-tier vertical builds

Technical Specifications