TurboKlone Spray Jets, 30 Pack of 360-Degree Aeroponic Misters

TurboKlone Spray Jets: Even Mist at Every Site

Each jet throws a full 360-degree spray pattern from its spot on the manifold. In an aeroponic cloner, that mist is the only water a bare stem receives until roots form. A single jet that clogs or wears leaves the cuttings around it dry while the rest stay wet. Replacing tired jets brings the spray pattern back to every site in the reservoir. These are the winged jets TurboKlone fits to its own machines. The wings act as an alignment guide, matching marks molded into the manifold. Press a jet onto its port and turn it until the wings line up with the indicator. Correct alignment is what sets the spray pattern TurboKlone intends for the chamber. TurboKlone lists the jets for its whole range, including the T24, T48, Elite 96 and Elite 144. Dome versions of those cloners use the same jets. The pack holds 30 jets, so one bag can refit a manifold and still leave extras. Installation is a press-and-turn job with no tools.

Keeping Aeroponic Misters Clean Between Runs

Hard water, nutrient salts and root debris all build up inside a small nozzle over time. Check the spray with the lid off and the pump running before loading new cuttings. A healthy jet throws a wide, even ring of mist. A sputtering jet or a thin stream points to a blockage or a worn opening. Pull the problem jet, rinse it under warm water, and clear the opening with a soft brush. Many growers soak jets in a mild vinegar solution to loosen mineral scale. Swap in a fresh jet from the pack if the old one still sprays unevenly. Clean the pump intake at the same time, since debris often starts there. Running plain water for the first days of a cutting run keeps salts out of the nozzles. Between batches, empty the reservoir and flush the manifold with clean water. Store spare jets in their bag so dust stays out of the openings. A full set of new jets at the start of a run removes one variable from the rooting results.

Key Features

• 360-degree spray pattern: Covers every cloning site around the manifold with even mist.
• Winged alignment: Wings match the indicator marks on the manifold for correct setup.
• TurboKlone fit: Listed for the T24, T48, Elite 96 and Elite 144, dome versions included.
• Tool-free install: Press onto the port and turn to align.
• 30 per pack: Enough to refit a manifold and keep spares.

Technical Specifications